Doing so allows your traffic to "hop" from the first location to the second before exiting at your destination. When using our config generator in step two, you have the option of selecting a second server location. To verify that WireGuard is working, use our Connection check to check your IP and verify that you don't leak DNS. Wg-quick down se3-wireguard Verify your connection Run the following command but replace se3 with your selected location's alias.Īs before, replace se3 with your selection. Turn on WireGuardįor this guide, we have selected Malmö, Sweden (se3), as our first server location. Sudo chown root:root -R /etc/wireguard & sudo chmod 600 -R /etc/wireguard 3.
Save the downloaded file in your local directory and then copy its content to /etc/wireguard.Īlso make sure you set the correct permissions so only root can read them: You will otherwise likely run into connectivity issues. If you're running WireGuard on multiple devices, generate a separate key pair for each device and each connection. Options include enabling a kill switch and selecting two locations for multihopping. Use our WireGuard config generator to automatically generate the necessary file. This applies to Fedora 32 and newer (using kernel 5.6 or newer).įor other Linux distributions, follow the official installation instructions. Sudo apt update & sudo apt install openresolv wireguard
Users with Debian releases older than Debian 11 (Bullseye) should first enable backports. This applies to Ubuntu (using kernel 5.4 or newer). The Mullvad VPN app for Linux uses the WireGuard protocol by default, so all you need to do is connect. We also have an advanced terminal-only setup guide. We'll walk you through our easy browser-based configuration setup and the necessary terminal-based commands to use the WireGuard® protocol with Mullvad on Linux.
0 kommentar(er)
